4Ws Mixing Right(4Wsmix Right); 4Ws Mixing Travel(4Wsmix Travel); 4Ws Mixing Reverse(4Wsmix Reverce); 4Ws Mixing Key(4Wsmix Key) - Ko Propo EX-1 Instruction Manual

4WS Mixing Right(4WSMix RIGHT)

Adjusts the rear axle servo movement range when steering is
turned to the right.
Equivalent to (Balance R) in the [Steering Balance] function.
Right Position (white square)
Left Position (black square)
Center Position (black square)
Setting Range 0 - 100%(
Default
If the rear axle servo's direction has been reversed, use [4WS
Mixing Reverse] to adjust.
This setting percentage is a ratio against the movement angle
setting in the [4WS Mixing Travel] function.
If the 4WS Mixing trim is set to a large value, a large left/right
value discrepancy may result. If adjusting 4WS Mixing Right for
the first time, follow the procedures below.
Set 4WS Mixing trim value to 0.
Adjust 4WS Mixing trim so that the car drives in a straight line
when steering is in neutral position.
Use 4WS Mixing Travel to match the overall steering angle
range.
Use 4WS Mixing Left and 4WS Mixing Right to match the left/
right turning radii.

4WS Mixing Travel(4WSMix TRAVEL)

Adjusts the overall amount of movement of the rear axle servo
when the steering is at full lock.
Setting Range 0 - 150%(
Default
Steering will not operate if the 4WS Mixing Travel value is set to 0.
:70%)
:100%)

4WS Mixing Reverse(4WSMix REVERCE)

This function reverses the rear axle's movement direction.
Setting Range
NOR , REV
(Normal) (Reverse)
Steering direction varies from car to car and should be checked
when the R/C equipment has been installed.

4WS Mixing Key(4WSMix KEY)

Assigns ET keys to be used for 4WS Mixing.
Setting Range ( :OFF)
Default
MODE :OFF, ET1 - 5
(4WSMix MODE)
LEFT :OFF, ET1 - 5
(4WSMix LEFT)
CENTER
(4WSMix CENTER)
RIGHT :OFF, ET1 - 5
(4WSMix RIGHT)
TRAVEL
(4WSMix TRAVEL)
ET keys may also be assigned via the [Setup] function in the
System Menu.
Convenient for when you need to adjust 4WS Mixing settings.
38
( :NOR)
Default
:OFF, ET1 - 5
:OFF, ET1 - 5