Throttle Mixing(T-Mix); Throttle Mixing Brake(T-Mix Brake); Throttle Mixing Center(T-Mix Center) - Ko Propo EX-1 Instruction Manual

Throttle Mixing(T-Mix)

Mainly used for 1/5 scale R/C cars where the left/right front
wheels' braking operation is controlled by an independent servo.
If 3CH is assigned to front right wheel brake and 4CH
is assigned to front left wheel brake, they will operate in
conjunction with 2CH (throttle) and 1CH (steering).
Example Simplifies adjustment of the independent brake
channel (servo) on 1/5 scale R/C cars.
[Functions]
Throttle Mixing Brake
Modify the maximum amount of front brake servo movement.
Throttle Mixing Center
Modify the front brake servo's neutral position.
Throttle Mixing High Point
Modify the maximum amount of throttle to be applied to the
front brake servo.
To avoid operating only the brakes, set value to 0.
Throttle Mixing Reverse
Modify the front wheel brake servo's movement direction.
Throttle Mixing Curve
Modify the front wheel brake servo's movement speed ratio.
Throttle Mixing Delay
Delays the operation of the front wheel servo brake.
Throttle Mixing Steering
Modify the amount of brake applied by the front wheel brake
servo in relation to steering input.
Throttle Mixing On/Off
Enables Throttle Mixing to be activated via ET keys.
Throttle Mixing Key
Assigns ET keys to be used for Throttle Mixing.

Throttle Mixing Brake(T-Mix BRAKE)

Adjusts the maximum amount of front brake servo movement.
Brake Position
(white square)
Setting Range 0 - 150%(
Please begin with the same value set for front right brake (3CH)
and the front left brake (4CH). If the car's becomes unbalanced
during full braking, then there is a discrepancy between the left
and right which should be corrected.
An overly high setting value will increase load on the servo and
lead to it being damaged. Check carefully while adjusting.
Forward movement will be inoperable if the value is set to 0.

Throttle Mixing Center(T-Mix CENTER)

Modify the front brake servo's neutral position.
Center Position
(white square)
Setting Range -80 - 80%(
The points at which the front right brake (3CH) and front left brake
(4CH) begin to operate is vital. If these are not adjusted, the car
will become unbalanced under braking.
The setting position cannot exceed what is set by [High Point] or
[Brake].
42
High Position Center Position
(black square) (black square)
:100%)
Default
High Position Brake Position
(black square) (black square)
:0%)
Default