● VR information setting
Adjust the steering and throttle resistance
information.
※ Please perform the VR information
configuration to calibrate your system.
○ When using EX-RR for the first time.
○ When changing a steering unit for a different
product or when putting it back together.
○ When changing a grip unit for a different product
or when putting it back together.
○ When using and confusion has occurred in the
positional information.
1.Select [FUNCTION] on the initial screen and
push the ENTER key.
2.Select [SYSTEM] on the function screen
and push the ENTER key.
3.Select [VR INFO] on the system screen and
push the ENTER key.
4.Move the wheel slowly to the full left and
right lock (numbers will change as the
steering is moved) and release the wheel
back to neutral.
5.Move the trigger slowly to the full throttle
and full brake positions (numbers will change
as the throttle is moved) and release the
trigger back to neutral.
6.Then select YES (press ENTER) to adjust
and save the settings.
3.Example before setting
VR INFOMATION VRインフォメーション
ヒダリ
ST- LEFT
センター
NUT
ミギ
RIGHT
ゼンシン
TH- HI
センター
NUT
ブレーキ
LOW
4.5.Move slowly to full stroke, then release.
左 最大
右 最大
6.Small window [Yes] comes active.
※ When operating the VR INFORMATION and
pressing the BACK key will cancel the operation.
For a detailed configuration procedure, please refer to
"VR Information" (p.38).
2204
2198
2
2194
OK?
2078
YES
2075
2072
前進 最大
後進 最大
◇
OK?
YES
◇
● How to change the Modulation mode
EX-RR has two Modulation modes.
※ When attaching the Xpansion unit, this operation
is the same.
《Functions》
● General RC models FHSS mode: LED Solid
Operating the general receivers such as
KR-211FH/KR-241FH Only receivers using FHSS
will work.
The receiver of other methods (DSSS/27/40MHz)
do not work.
● Mini-Z MHS mode :LED Flashing slowly
Operating Kyosho Mini-Z MHS mode. (MR-03 VE
PRO)
* Functions that are in Mini-Z will be lit up at initial screen.
Only MiniZ using MHS will work. Does not work with
ASF, FHS, general RC cars.
① Turn off EX-RR switch.
② Push the ET1 lever to the left and power on.
③ Hold ET1 lever until the buzzer sounds and the
LED of EX-RR turns on (approximately two seconds ).
Power
ON
If the pilot LED is blinking fast, this is a warning
that the battery voltage is low. Please change to
new batteries or for a battery pack which has been
charged.
Model selection changes and modulation mode
changes are not linked.
18
ET1
Appr o ximately t w o
seconds, LED turns on.