Steering Turn Speed(Turnspeed); Steering Return Speed(Retnspeed) - Ko Propo EX-1 Instruction Manual

Steering Turn Speed(TurnSpeed)

This function limits the maximum speed of the steering servo
by adjusting the steering turn direction [TURN] setting. The
steering angle between neutral and full lock is split into two
zones and each may be adjusted independently (2WAY).
Setting Range
TURNPOS:1 - 100%(
Default
This sets the point at which the two speed zones are split.
TURN 1:1 - 100%(
Default
:100%)
This sets the speed from when the steering has begun to turn.
TURN 2:1 - 100%( :100%)
Default
This sets the speed from after the split to the second zone.
You can set the speed to be slow during initial turning, then
subsequently faster.
If your car flips on high-grip surfaces, lower the [TURN 1] value to
make cornering easier.
[Changing to 1WAY]
Changing [TURNPOS] to 100 will deactivate [TURN 2] and [TURN
1] will be used to set the speed.
Take into account such factors as the servo used, car, driving
surface, etc. when adjusting all settings. Conduct test drives to find
the best setting values.
Effective speed values are dependent on the speed characteristics
of your selected servo.
(N:Neutral)
:50%)

Steering Return Speed(RetnSpeed)

This function limits the maximum speed of the steering servo
by adjusting the steering return direction [RETURN] setting.
The steering angle between neutral and full lock is split into two
zones and each could be adjusted independently (2WAY).
Setting Range
RETNPOS:1 - 100%(
This sets the point at which the two speed zones are split.
RETN 2:1 - 100%(
Default
This sets the speed before the split position point.
RETN 1:1 - 100%(
Default
This sets the speed from after the split to the second zone.
[Changing to 1WAY]
Changing [RETNPOS] to 100 will deactivate [RETN 2] and [RETN 1]
will be used to set the speed.
Take into account such factors as the servo used, car, driving
surface, etc. when adjusting all settings. Conduct test drives to find
the best setting values.
Effective speed values are dependent on the speed characteristics
of your selected servo.
22
(N:Neutral)
:50%)
Default
:100%)
:100%)