Analog(Analog) - Ko Propo EX-1 Instruction Manual

ANALOG(ANALOG)

These settings are to enable continuous output for channels 3
or 4.
CCEN Position (white square)
LLOW Position (black square)
HHIGH Position (black square)
Setting Range
KEY:OFF, ET1 - 5, BT1(
Default
Assigns a key to use for switching positions.
REVERSE:NOR , REV
(Normal)
Sets operation direction.
STEP:1 - 25( :5)
Default
Sets the amount of change for the operation.
LOW :-100 - 0(
(Low Position)
Sets the lowest value for the operation range.
CEN :LOW - HIGH(
(Center Position)
Sets the neutral position for the operation range.
HIGH :0 - 100(
(High Position)
Sets the highest value for the operation range.
How to Use Analog Settings
Low Position Side:
Between LOW and CEN are 100 steps within which the intervals can be
adjusted.
High Position Side:
Between CEN and HIGH are 100 steps within which the intervals can be
adjusted.
Example)When STEP value is 2
When LOW side is set to 5 intervals.
When HIGH side is set to 4 intervals.
Center position is the staring position.
Low/High positions cannot be exceeded. Operations which try to
do so will stop just before the Low/High positions.
:OFF)
( :NOR)
(Reverse) Default
Default
:-100)
:0)
Default
:100)
Default
36