Procedures Prior To Operation - Ko Propo EX-1 Instruction Manual

■ Procedures Prior to Operation

1.Switching On
After ensuring that it is safe to do so, switch on the transmitter followed by the receiver.
This product uses the FHSS transmission system, which switches between frequencies in the2.4GHz range at a high speed.
FRANCE Mode needs to be selected if this product is to be used in France, while other countries should use GENERAL Mode.
(If the mode is switched between GENERAL and FRANCE, pairing procedure must be done with the receiver again.)
2.Model Confirmation
Confirm the model which will be used.
3.Checking Movements
With the model's wheels lifted off the ground, operate transmitter to check for proper
movement. While driving, use steering and throttle trims to make fine adjustments. Drive in a
figure 8 pattern to check steering balance.
Use the [Quick Setup] function to easily arrange the initial settings.
See[Trim and Sub Trim Operation] on the following page.
4.Switching Off
After a driving session, switch off the receiver, followed by the transmitter. Remove the
battery pack from the model.
After switching off, wait at least 5 seconds before switching on again to ensure proper operation.
An alarm will sound if the controls are idle for **minutes. Operate the transmitter to stop the alarm.
Figure 8 Pattern
Stand
13
Trim