Edge-Core ECS4510-28P User Manual page 1272

| LLDP Commands
C 44
HAPTER
lldp tx-delay
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
When LLDP is re-initialized on a port, all information in the remote systems
LLDP MIB associated with this port is deleted.
E
XAMPLE
Console(config)#lldp reinit-delay 10
Console(config)#
This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the
no form to restore the default setting.
S
YNTAX
lldp -delay seconds
tx
no lldp -delay
tx
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
D S
EFAULT ETTING
2 seconds
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The transmit delay is used to prevent a series of successive LLDP
◆
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
This attribute must comply with the following rule:
◆
(4 * tx-delay) ≤ refresh-interval
E
XAMPLE
Console(config)#lldp tx-delay 10
Console(config)#
– 1272 –