Installing The Fitting - Otto Bock Avantgarde CV Service Manual

Service Work

3.11.2.2 Installing the Fitting

The rear wheel can be installed at 12 height positions in the rear wheel adapter.
1) Slightly loosen the nuts on both sides of the fitting (see Fig. 129, see Fig. 130).
2) Pull the camber washers apart until the fitting can be moved (see Fig. 131).
3) Move the fitting together with the nuts and camber washers into the desired position.
4) Pay attention to the following when installing the fitting (see Fig. 131):
→ Position the camber washer teeth offset from one another.
→ Position the camber washer groove as parallel and upright as possible.
5) Insert the spirit level holder into the groove (see Fig. 132, item 1).
6) Insert the spirit level and align the camber washers upright (see Fig. 132, item 2).
7) Tighten the nuts on both sides of the fitting to 50 Nm.
→ Once changed, the left and right fitting must have the same vertical position in the rear wheel adapter.
42
127
129
128
130
02/2011