Replacing Anti-Tipper Rollers; Retrofitting The Transport Wheels; Retrofitting The Horizontal Accessory Mount - Otto Bock Avantgarde CV Service Manual

3.5.3.4 Replacing Anti-Tipper Rollers

The replacement is made without tools by pulling out the plug-in tube.

3.5.4 Retrofitting the Transport Wheels

CAUTION
Incorrect adjustment of the transport wheels
Risk of falling, tipping of the user
► Align the transport wheels to the rear while installing.
► Verify that the transport wheels have been set to the same height before using them.
1) Press the transport wheel latch pin in (see Fig. 29).
2) Insert the transport wheel true to side into the vertical accessory mount.
3) Adjust the height of the transport wheels (see Fig. 30). Adjust the height so that the transport wheels are approx.
2 cm above the ground when the rear wheel is installed.

3.5.5 Retrofitting the Horizontal Accessory Mount

The horizontal accessory mount is required for the installation of the tip-assist and the crutch holder (see Fig. 31).
► Screw the mounting screws (above/inside) into the holes on the frame to 8 Nm (see Fig. 32).
02/2011
27
29
Service Work
28
2 cm
30
19