Tensioning The Spokes/Adjusting The Out-Of-Round; Adjusting The Quick-Release Axle; Retrofitting The Tetra Axle - Otto Bock Avantgarde CV Service Manual

Service Work
3) Tightly bolt the push rings onto the rim in narrow or wide installation position.
4) Completely reinstall the tyre.

3.11.6.3 Tensioning the Spokes/Adjusting the Out-of-Round

Tensioning the spokes
1) Completely remove the tyre (see Fig. 145).
2) Check the spokes' tension by shaking/moving the spokes.
3) If necessary, carefully adjust the tension of the spokes with spoke tensioner.
4) Completely reinstall the tyre.
Adjusting the out-of-round
Adjusting the out-of-round to 1 mm maximum requires special instruments and technical knowledge. The adjustment
should be performed in a bicycle specialist workshop.

3.11.6.4 Adjusting the Quick-Release Axle

The quick-release axle (see Fig. 146) should be adjusted so that it engages properly and so that the wheel has no play
on the axle.
1) Hold the tip of the quick-release axle with a wrench (size 11).
2) Adjust the play by turning the nut on the end of the quick-release axle (size 19; see Fig. 146, item 1) in or out.

3.11.6.5 Retrofitting the Tetra Axle

1) Remove the quick-release axle with rear wheel.
2) Exchange quick-release axle for tetra axle.
3) Insert rear wheel with tetra axle into the fitting.
46
144
146
145
147
02/2011