Retrofitting The Vertical Accessory Mount - Otto Bock Avantgarde CV Service Manual

Service Work

3.5.2 Retrofitting the Vertical Accessory Mount

INFORMATION
The vertical accessory mount and the frame accessories cannot be installed on the welded Avantgarde CLT.
The vertical accessory mount is required for the installation of the anti-tipper and the transport wheels (see Fig. 18,
item 1).
The vertical accessory mount can be installed in two positions.
1) Remove the rear reflector from the rear frame (see Fig. 19).
2) Hold the vertical accessory mount against the inside of the frame tube with the rounded side towards the frame
tube (see Fig. 20).
3) Bolt on the accessory mount:
→ Insert a screw with washer from the outside through the frame tube (see Fig. 21, item 1).
→ Thread a nut from above into the profile of the vertical accessory mount (see Fig. 21, item 2).
→ Hold the nut (see Fig. 21, item 3) and tighten the screw from the outside to 7 Nm.
16
16
18
17
19
02/2011