Replacing The Cross-Brace/Cross-Brace Bracket - Otto Bock Avantgarde CV Service Manual

Service Work

3.5.1.3 Replacing the Cross-Brace/Cross-Brace Bracket

INFORMATION
The frame components are no longer connected when the crossbrace is removed. Carefully lay the frame compon­
ents on the work surface one after another.
1) Remove both front parts of the frame (see Page 12).
2) Unscrew the cross-brace centre screw and remove (see Fig. 11).
3) Remove the cross-brace bracket retaining clip (see Fig. 12).
4) Remove the end caps (see Fig. 13).
5) Remove the cross-brace upward (see Fig. 14) and replace.
6) To reassemble, perform these steps in reverse order. Tighten the centre screw to the point that folding without jam­
ming is possible.
14
7
9
11
8
10
12
02/2011