Adjustment Of The Anti-Tipper; Replacing The Pivot Arm - Otto Bock Avantgarde CV Service Manual

Service Work

3.5.3.2 Adjustment of the anti-tipper

Height adjustment of the anti-tipper
1) Unscrew the mounting screw of the anti-tipper tube from the accessory mount (see Fig. 22, item 2).
2) Move the anti-tipper tube in the vertical accessory mount.
3) Bolt down the anti-tipper tube. The distance between the anti-tipper rollers and the ground must be 5 cm maximum
(see Fig. 23).
Angle adjustment of the pivot arm
1) Remove the pivot arm mounting screw from the anti-tipper tube (see Fig. 24, item 1).
2) Move the pivot arm to a new position (3 setting possibilities: (see Fig. 24, item 2). The distance between the anti-
tipper rollers and the ground must be 5 cm maximum.
3) Bolt down the pivot arm.
Longitudinal adjustment of the pivot arm
1) Press the button on the pivot arm (see Fig. 25).
2) Adjust the length of the pivot arm. In doing so, the rocker's outer arm should protrude beyond the largest diameter
of the tyre (see Fig. 26).
3) Allow the button to engage.

3.5.3.3 Replacing the Pivot Arm

1) Unscrew the screwed tube connection to the pivot arm (see Fig. 27) through the service opening (see Fig. 28).
2) Remove and replace the pivot arm.
3) To reassemble, perform these steps in reverse order. Tighten the pivot arm screw connection to 4 Nm.
18
23
25
24
26
02/2011