Replacement Work On The Cs/Clt Model; Replacing The Foot Rest Bar; Replacing The Foot Plate; Replacing The Tube Foot Rest - Otto Bock Avantgarde CV Service Manual

3.6.3 Replacement Work on the CS/CLT Model

3.6.3.1 Replacing the Foot Rest Bar

1) Unscrew/remove the size 5 Allen head screw on the inside of the front frame (see Fig. 53).
2) Remove and replace the foot rest bar (see Fig. 54).
3) The foot rest bar must be pushed at least 60 mm into the swivel segment.
4) Tighten the screws to 8 Nm.

3.6.3.2 Replacing the Foot Plate

1) Unscrew the size 5 Allen head screw at the under foot rest bar (see Fig. 55).
2) Remove the foot plate (see Fig. 56).
3) To reassemble, perform these steps in reverse order. Tighten the Allen head screw to 10 Nm.
3.6.3.3 Replacing the Foot Plate
The instructions for the CV model apply (see Page 22).

3.6.3.4 Replacing the Tube Foot Rest

1) Flip up the tube foot rest.
2) Release and flip up the lateral cover for the angle adjustment (see Fig. 57, item 1).
3) Unscrew the size 5 Allen head screw (see Fig. 57, item 2).
4) Remove/replace the tube foot rest from the lateral mounting (see Fig. 58).
5) Position the tube foot rest in place and tighten the Allen head screw to 10 Nm.
6) Set the width of the tube foot rest by adjusting the screw (see Fig. 59).
7) Flip down the tube foot rest and close the lateral cover for the angle adjustment.
02/2011
53
55
Service Work
54
56
25