Loading New Firmware Into The Eccellenza Pod - VKI Technologies Eccellenza Pod Service Manual

Error Messages
8. After the file is written to the programmer, a confirmation message appears on the
screen. If any errors prevented the file from being written, they will be displayed in
this area. Also notice that at the lower right of the screen, it reads "Pass=1" – this
indicates that one file has successfully passed the writing process.
9. If you are finished loading files into the programmer, we recommend that you close
the CCS Programmer Control Software application on your PC first, and only then
disconnect the USB cable from your PC.

Loading New Firmware into the Eccellenza Pod

1. Switch off the power to the machine.
2. Remove the rear panel from the machine.
3. Locate the firmware update port in the center of the control board. Newer machines
are equipped with an RJ25 connector (left image) and older machines use a special
port on the control board (right image).
74
Eccellenza Pod