VKI Technologies Eccellenza Pod Service Manual page 43

Eccellenza Pod
6. Install the new valve manifold onto the valve port of the water tank. Make certain
the two O-rings are installed on the valve inlet and that the valve is pushed
into the valve port as far as it can go.
7. Lower the water tank back onto its front and rear supports.
8. Connect the outlet hoses onto the outlet valves.
9. Connect the wiring onto the outlet valves
a) White pair ► Powder Valve
b) Yellow pair ► Hot Water Valve
10. Turn on the water supply, connect the service cord to the wall outlet and switch on
the machine power.
11. Allow the water tank to fill and check for leaks.
12. Test the machine to make certain everything is functioning properly.
13. Install the rear panel and the top panel.
Replacing Components
43