VKI Technologies Eccellenza Pod Service Manual page 36

Replacing Components
7. Peel off the backing from the adhesive on the new selection board and install the
backing onto the old selection board.
8. The inside of the front door is equipped with four small alignment tabs (one for each
corner of the board). Lightly place the selection board onto these four alignment
tabs. Once satisfied that it is in the proper position, apply light pressure with your
fingers to the back of the board to make it stick to the door. Avoid touching any of
the IC chips when applying the pressure.
9. Connect the wiring from the LCD to the selection board.
36
Eccellenza Pod