Power Supply - VKI Technologies Eccellenza Pod Service Manual

Eccellenza Pod

Power Supply

1. Switch off the machine power and disconnect the service cord from the wall outlet.
2. Remove the waste bin and remove the rear panel.
3. The three screws that secure the power supply in place are located on left wall on
the waste bin area. These screws require a smaller tipped Philips screwdriver than
the one typically used for the other screws in the machine.
4. Slightly loosen the three screws securing the power supply to the wall. Do not
remove these screws.
5. From the rear of the machine, lift up the power supply and pull it away from the wall on
which it is mounted. Once cleared from the wall, pull the power supply towards you.
6. Disconnect the two wiring harnesses from the power supply.
Replacing Components
29