VKI Technologies Eccellenza Pod Service Manual page 37

Eccellenza Pod
10. Re-install the front door onto the machine by sliding it down onto the hinges.
11. Connect the wiring from the machine onto the front selection board.
NOTE: This particular connector is square (2 rows x 2 columns) and must be
installed correctly. Pin one on the connector is identified with a small arrow
and this arrow must be pointing to the top left pin on the board connector.
12. Switch the machine power ON, and check the contrast on the LCD screen. If the
contrast needs to be adjusted, it can be done using the potentiometer next to the
LCD connector on the selection board. Once set, switch the machine power OFF.
Replacing Components
37