Section 6 - Updating Firmware - VKI Technologies KEURIG Eccellenza touch Operation Manual

Updating Firmware
Never attempt to install an older version of software than the version
currently installed in your equipment as it is not backwards compatible! This
may result in a failure of the HMI (touch screen) and void its warranty.
Firmware updates may be released periodically for the Eccellenza Touch. These updates may
consist of fixes, new options and features, customizations, etc. This section guides you through
the simple process of updating your equipment to the latest firmware.
After replacing the control board, the firmware must be loaded when the
machine is first powered up. Do not power up the machine until the USB
Flash drive with the proper firmware is connected to the machine.
1. Load the latest firmware files onto an empty USB flash drive (minimum 8GB).
2. Remove the waste bin.
3. Remove the plug from the USB connector and insert your USB flash drive into it. Make
sure to push the USB flash drive into the USB connector as far as it can go.
4. Reboot the machine using the main power switch (switch the power off for 5 seconds
and then on again).
VKI Publication #100308-003
S
E C T I O N
Eccellenza Touch
6
105