Error Messages
Updating Equipment Firmware
To update the firmware in the Eccellenza Pod machine, a Load-n-Go handheld programmer
(shown below) is required. Should multiple different firmware files become available for the
Eccellenza Pod, you can load up to four of them onto this one programmer.
NOTE: VKI Technologies does not sell this programmer. It can be purchased
online at www.ccsinfo.com. Please visit this web site for more details.
Software Installation
1. Insert the CD Rom provided into your computer drive.
2. Click on the ccsload folder and select setuccsload.exe.
3. Allow the installation process to complete.
4. Click on the USB-Drivers folder (on CD-Rom).
5. Select usbdrivers.exe and follow the instructions for installing the driver and adding
the new hardware.
6. See the included Help File on the CD (CCSLoad.CHM) for more assistance after
installation.
Hardware Installation
1. Insert four AA batteries into the battery compartment in back of the Load-n-Go
programmer.
2. Connect the Load-n-Go programmer to your PC via the USB cable provided.
3. Run the ccsload.exe software that was installed on your PC (a shortcut should have
been left on your desktop).
70
Eccellenza Pod