VKI Technologies Eccellenza Pod Service Manual page 75

Eccellenza Pod
4. On older machines, connect the special programming cable to the firmware update
port in the center of the control board. Note that this connector must be installed in
a specific way (illustrated below). On newer units, connect the phone type cable
directly to the RJ25 connector on the control board.
The three larger silver colored guide pins must align with the three contacts on the
control board, and the four plastic clips on the connector must align with the four
small holes in the control board. Once aligned, compress the sides of the connector
slightly and push the connector onto the board until it locks in place.
Error Messages
Newer machines (and control
boards) are equipped with an
RJ25 phone type connector.
75