Selection Board Or Lcd Display - VKI Technologies Eccellenza Pod Service Manual

Replacing Components

Selection Board or LCD Display

1. Switch off the machine power and disconnect the service cord from the wall outlet.
2. Remove the top panel and open the front door and remove the screws that secure
the selection board cover to the door.
3. Disconnect the wiring from the selection board.
a. If you are replacing the LCD display, remove the two screws that secure the
LCD to the door and replace the LCD. If replacing the selection board, proceed
to the next step.
34
NOTE: The two upper screws are
each equipped with a small plastic
spacer. This spacer also holds the
screws in place to simplify the re-
installation of the board cover. Do
not lose these two spacers!
Eccellenza Pod