VKI Technologies Eccellenza Pod Service Manual page 57

Eccellenza Pod
9. While pressing down on the locking clip at the front of the plate, press down on the
clip at the rear of the plate, and push it out through to the front.
10. Remove the base, gasket and impeller from the old motor and transfer it to the new
motor.
11. Install the new motor into the cutout in the whipper mounting plate. Install the
bottom of the assembly first, and then push the top of the assembly into the cutout
until the plastic clip locks it in place.
12. Turn the handle on the locking ring completely to the right and secure the base to
the wall with a screw.
Replacing Components
57