Reassembling The Front Wheel - Husqvarna TE 250-450-510/2008-I.E. Owner's Manual

Table of Contents

Available languages

REASSEMBLING THE FRONT WHEEL

Fit the L.H. spacer on the wheel hub.

TE-TC-TXC: Fit the wheel between the front fork legs so that the

brake disc is fitted into the caliper.

SMR: Fit the wheel between the front fork legs.

Fit the wheel axle (2) from the R.H. side, after greasing it and

push it to the stop on the L.H. leg; during this operation, the

wheel should be turned. Tighten the screw (3) on the fork L.H.

side but DO NOT lock it. Now, pump for a while, pushing the

handlebar downwards until you are sure that the fork legs are

perfectly aligned.

Lock: the screws (1) on the R.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7

ft-lb), the screw (3) on the L.H. side (51,45 Nm/ 5,25 Kgm/

38 ft-lb), the screws (1) on the L.H. leg (10,4 Nm/ 1,05 Kgm/

SMR: fit the brake caliper on the disc; assemble the caliper on

its holding plate and tighten the screws (A) at 25,5 Nm/ 2,6

Kgm/ 18.8 ft-lb.

Check that the brake disc slides between the caliper pads with-

out any friction.

After reassembly, pump the brake control lever until the pads

are against the brake disc.