Reassembling The Front Wheel - Husqvarna CR 125 2011 Workshop Manual

CR 125 2011 - WR 125 2011
1
2
1
CHASSIS AND WHEELS

Reassembling the front wheel

Fit the L.H. spacer on the wheel hub.
H06857
Fit the wheel between the fork legs so as to set the brake disc into the calliper.
Fit the wheel axle (2) from the R.H. side, after greasing it and push it fully
3
home against the L.H. fork leg; during this operation, the wheel should be
turned.
H06858
Tighten the screw (3) on the fork L.H. side but DO NOT lock it. Now, pump for a
while, pushing the handlebar downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (1) on the R.H. leg (10.4 Nm, 1.05 Kgm, 7.7
ft/lb), the screw (3) on the L.H. side (51.45 Nm, 5.25 Kgm, 38 ft/lb), the screws
(1) on the L.H. leg ( 10.4 Nm, 1.05 Kgm, 7.7 ft-lb).
After reassembly, pull the brake control lever until the pads are
against the brake disc.
Y.7
Workshop Manual Ed. 06-2011