Ducati 750 Sport Owner's Manual page 55

A\
. = =¿ ~ JA~A e .¡ I 00 '
o' J J
o
o
49
Fitting the head -750
This figure shows the various components
of the head and timing group assembly:
The bare head.
The ball bearing.
The two distance pieces.
The gasket.
The timing support, in which the
bearing and conical gear
with transmission
shank must be fitted.
- The gasket.
- The flange.
Before fitting the timing support in the
head, the conical gear and appropriate
bearing must be fitted.
Fitting the head -860
This figure shows the various components
of the head and timing group assembly, in
the fitting order:
The head.
- The ball bearing.
- The two distance pieces
- The timing support, in which the
bearings, the gasket, the shim rings and
the two seegers must be fitted.
- The conical gear.
- The fixing screws, the flange, the
rubber. and the gasket.
Important:
Before fitting the timing support in the
head, the conical gear and appropriate
bearing must be fitted.
The head and corresponding camshaft
group-750
This figure shows the various components
of this assembly, which are fitted in the
following order:
The bearing holding cap.
The camshaft and key.
The conical gear.
The lock washer.
The fastening nut.
For this assembly, tool # 88713;0263
should be used. Tighten the lock washer
after the nut has been
fastened.