20
Removing the clutch side cover
Remove the screws holding the Gover,
th~n remove. the cover by inserting
extractor # 88713.0258 in place of the
plug and turning the extractor until the
cover comes off. Continue rotating the
extractor while tapping on the cover with
a plastic hammer to allow the cover to
come off evenly. Never insert a screw-
driver between the sealing surfaces.
Removing the clutch
Remove, the sbç screws, the springs and
the cups and pull out the clutch plates.
Removing the drum and clutch housing
In order to prevent the engine from'
rotating, insert the special ,tool
# 88713.0101 as shown. Then open the
lock washer and unscrew the nut, using a
30 mm wrench. Now remove the drum and
the clutch housing.