Ducati 750 Sport Owner's Manual page 41

Ducati motorcycles owner's manual
Hide thumbs Also See for 750 Sport:
Table of Contents

Advertisement

35
Fitting the driving gear
The conical driving gear is fitted on the
driving shaft. Make sure that the reference
mark coincides perfectly with the mark on
the driven gear. It is important to check the
meshing su rfaces of these gears for proper
alignment. It may be necessary to insert
shims until the proper alignment is obtain-
ed. This alignment must be checked again
when fitting the bush and the ignition
distributor.
Fitting the conical driving gear of the upper
bevel gears
Fit the thickness washers, insert the keys,
position the conical gear and fit the other
thickness washers. Then
fit the bearing
holding bush as outlined in the next
illustration.
Fitting the side bevel gears
First insert the conical gear from the lower
side, being careful that the reference mark
coincides with one of the two marks on the
central conical gear. The other mark on the
central gear is used to fit the conical gear
on the opposite side.
Next, the thickness washers are fitted.
Then fit the bearing holding bush. To do
this, tool # 88713.0111 should be screwed
on the bush itself. Then tap on the bush
with a plastic hammer until it seats
properly. Then fit. the thickness washers
and the Seeger ring. The conical gear on
the opposite side is fitted in the same
manner.

Advertisement

Table of Contents
loading

This manual is also suitable for:

750 gt860

Table of Contents