Download  Print this page

Ducati 750 Sport Owner's Manual Page 47

Ducati motorcycles owner's manual.
Hide thumbs

Advertisement

41
Fitting the flywheel-gear assembly
Carefully clean the shaft and gear cones
and check for any irregular surface or
dents. Check the condition of the key
and
its seat. Then fit the assembly, the stop
washer and the fastening nut.
Fitting of stator-plate (electronic ignition
generator)- 860
Carefully clean the plate seat, then pass
the two cables through the opening until
they come out of the crankcase hole. Then
fit the plate in its seat and fix it with the
three screws which have to be tightened in
a way that the stator-plate may rotate. .
The stator-plate will be finally fixed later,
after the ignition-advance has been
adjusted.
Then the two cables will be fitted to the
crankcase by means of a threaded rim,
under which must be positioned a thrust
washer and its rubber gasket.
The rim will later be tightened with a
30 mm box wrench, the two cables passing
through the wrench.
Fitting the gear selector lever and rod
i nsert the stop plate in the notch of the rod
and fit the blockto be fixed with one screw
only, using a 5 mm hexagonal wrench.

Advertisement

Table of Contents

   Also See for Ducati 750 Sport

This manual is also suitable for:

750 gt860

Comments to this Manuals

Symbols: 0
Latest comments: