Download  Print this page

Ducati 750 Sport Owner's Manual Page 49

Ducati motorcycles owner's manual.
Hide thumbs

Advertisement

43
Fastening the nut fixing the flywheel-gear
assembly
With the same tool # 88713.0101 placed as
shown in the figure, tighten the nut with a
36 mm wrench. Then tighten the lock
washer.
Fitting the clutch
In the hole of the main shaft fit: a rod, a
6 x 6 mm bearing, another rod, and another
6 x 6 mm bearing.
Then fit the set of clutch plates in the
followingorder: alternate one driving plate
and one driven plate until all
16 plates have
been installed, with the last driving plate
having the outer teeth towards interior.
Then fit the pressure plate and the shim
with its counternut.
IMPORT ANT:
Before fitting the gear selector cover,
install the following parts in the trans-
mission shaft hole from the selector cover
side: A 5/16 x 5/16 bearing, a 5/16 ball;
another5/16 x5/16 beadng; and a rod with
the ball part towards the clutch lever.
Fitting the clutch side cover
Fit the gasket and the cover and install the
ten screws. You will notice that all of the
screws are not the same size and the
longer ones should be installed where the
three reference dowels appear. Also, when
fitting the gasket, make sure that the oil
delivery hole is open. .

Advertisement

Table of Contents

   Also See for Ducati 750 Sport

This manual is also suitable for:

750 gt860

Comments to this Manuals

Symbols: 0
Latest comments: