Fitting the alternator rotor
First fit the distance piece on the shaft and
fit the rotor and the stop washer. Then fit
tool # 88713.0108 on the rotor poles and
lean it on the starter shaft as shown in the
figure. Then fit the nut and tighten it with a
30 mm wrench. Then tighten the stop
860 Long distance piece.
This ilustration refers to caption "Removing the oil
pump block" which appears on page 27.
Fitting the chain pinion
This fitting must be carried out as follows:
- Fit the distance ring.
- Fit the chain pinion taking care to place
the higher hub towards outside.
- Fit the stop washer.
- Fit the threaded rim.
- Insert tool # 88713.0107 between the
- With the special wrench # 88713.0104
tighten the rim.
- Tighten the stop washer.
Fastening the threaded rim of the central
Fit tool # 88713.0108 on the rotor poles
and lean it on the starter shaft as shown in
the figure. Next, position the stop washer.
Screw in the rim and tighten it down with
box wrench # 88713.0105. Then fasten the
stop washer by bending one of the teeth in
one of the rim grooves.