Table of Contents
Advertisement
39
Fitting the ignition distributor control gear
Insert the key and position the ignition
distributor control gear and the Seeger
ring.
Fitting the half bushing
Fit the thickness washers and the half
bushing, positioning it as shown in the
figure. The thickness washers must be
positioned so that the half bushing upper
face is 100 mm higher than the ignition
distributor face. This is necessary to allow
the distributor to block the central gear
group and apply pressure against the
distributor gasket. After this is done, the
ignition distributor can be fitted. Once the
distributor is fitted, check the play in the
bevel gears to ensure that there is no play,
but they should not be tight.
Fitting the seal flanges of the side conical
gears
Fit the spacers and the flange as shown in
the illustration. With the gasket try to
eliminate the clearance between the
crankcase and flange so, at the same time,
the flange blocks the bevel gear housing:
Hide quick links:
Advertisement
Table of Contents
