Ducati 750 Sport Owner's Manual page 48

42
Fitting the thickness washer under the
clutch housing .
Remember to place the 1.5 mm thickness
washer, which appears in red, under the
clutch housing (3 mm 860)
Fitting the clutch housing
The clutch housing is
fitted on its shaft,
being careful that it is well centered in
respect to the driving gear fitted on the
flywheeL. Make sure there is no play or
tightness between these two gears.
Fitting the clutch drum
Fit the clutch drum on the same shaft as
the clutch housing and position the lock
washer. With special tool # 88713.0101,
placed as shown in the figure, fit the nut
and tighten it with a 30 mm box wrench.
Then tighten the lock washer.