Ducati 750 Sport Owner's Manual page 31

Ducati motorcycles owner's manual
Hide thumbs Also See for 750 Sport:
Table of Contents

Advertisement

25
Removing the bearing holding bushes and
conical gears - 750
First remove the flange and the Seeger
ring on the conical gear shank with a pair
of pliers. With pUller # 88713.0111 you can
then remove the bush and the bearings.
Removing the bearing holding bushes and
conical gears-860
Remove the four screws fixing the bush to
the. crankcase, then tap with a plastic
hammer until the block comes out.
IMPORT ANT:
The distance gaskets under the bush must
be kept apart, since they must be put in
the original place at the engine re-
assembling.
Removing the ignition distributor- 750
Set one piston at top dead centre and fit
the dial gauge, setting it at zero. Remove
the distributor and, after repairing it, refit
it, making sure it is timed correctly. Check
the advance in both cylinders and ensure
that the point gap is set at 4mm. If no
repairs are being made to the ignition
distributor, it is not necessary to remove it.
When repairing
the distributor, however,
be careful not to remove the half-bush
under it which retains the central conical
gear and shims.

Advertisement

Table of Contents
loading

This manual is also suitable for:

750 gt860

Table of Contents