Ducati 750 Sport Owner's Manual page 35

Ducati motorcycles owner's manual
Hide thumbs Also See for 750 Sport:
Table of Contents

Advertisement

29
Removing the countershaft bearing from
the half-crankcase timing side
This bearing is placed in a blind seat and
cannot be tapped out. Therefore it is
necessary to grip the bearing from the
bottom and remove it, using the special
puller # 88713.0270.
REASSEMBLING THE ENGINE
Refitting crankshaft gear
Before re-fitting the gear check the
wear of
the two oil seals; one inside the gear and
. the second fitted to the outside crankcase,
under the chain pinion.
Refitting the starter shaft
First, check the condition of the rubber
seal ring inside the shaft seat and replace if
necessary. Then fit the starter shaft, being
careful to insert the thrust washer in its
proper place. Then fit the screw holding
the pedal return spring.

Advertisement

Table of Contents
loading

This manual is also suitable for:

750 gt860

Table of Contents