Chain adjustment
With a special wrench # 88713.0115
inserted in the pin as shown in the figure,
rotate the eccentric to get the right
adjustment of the chain.
With a 13 mm wrench tighten the above
two bolts. Then refit the two plastic caps.
The chain must have 15-20 mm play with
the motorcycle on the ground and the
driver on the rear part of the saddle.
To adjust the chain it is necessary to follow
the preliminary instructions hereunder:
- Remove the two plastic caps of the
fork spindle.
- With a 13 mm wrench undo the bolts
on both sides of the motorcycle, as per the
figure.