23
Removing the stator-plate, electronic
ignition generator-860
Using a screwdriver, undo the three
screws fixing the stator plate to the
crankcase; then gently slip the two cables
from the crankcase.
Removing the chain pinion -750
Insert tool # 88713.0107 between the
teeth of the chain pinion and position it
against the crankcase. Then open the lock
washer and remove the fixing ring, using
tool # 88713.0104.
This operation is not necessary unless you
are repairing or replacing parts.
Removing the timing block-860
With a 6 mm hexagonal wrench unscrew
the four screws fixing this block to the
crankcase.