21
Removing the fixing nut on the flywheel
gear
With the special tool stil in position, open
the lock washer and unscrew the holding
nut, using a 36 mm wrench.
Removing the flywheel-gear assembly
-750
Fit puller # 88713.0110 on the gear and
allow the outer tool ring to slide until you
can grip the back of the gear with a pair of
pliers. Then use the puller to remove the
assembly from the shaft cone.
While performing this operation, use à
30 mm wrench as shown to prevent the
engine from rotating.
Removing the flywheel gear - 860
I nsertthe three pins of the 88713.0117 tool
in the three flywheel holes and rotate tool
clockwise, so that three teeth hook the
flywheeL.
Put the tool handgrip in drawing position,
then-using a plastic hammer-beat the
handgrip centre until the unit comes out of
the crankshaft.