Calibrate The Scannerocé Colorwave 650 Poster Printer - Oce ColorWave 650 User Manual

Calibrate the scannerOcé ColorWave 650 Poster Printer
When to do
Note:
Only roll position 1 can be used for calibrations.
Note:
Use only Océ 'Media' for reliable calibrations.
Note:
The printer will do the calibration automatically. You do not need to keep this printed
calibration chart.
Evaluate the Customer Analysis Tool print. If the print shows any output quality problems,
you can use this calibration wizard to check if the Océ ColorWave 650 Poster Printer
works properly.
The calibration will take several minutes. The printed output is delivered at the back of
the printer and led through the slot below the 'Top back cover'.
Caution:
If a delivery tray is installed, remove the delivery tray from the engine and remove its
data cable from the controller before you start the calibration.
Caution:
Calibration of the Océ ColorWave 650 Poster Printer is not possible while the printer is
in Roll-to-Roll mode. Make sure Roll-to-Roll mode is disabled.
Calibrate the scannerOcé ColorWave 650 Poster Printer
Chapter 8 - Print quality and Print productivity 307