Enable The Roll-To-Roll Mode - Oce ColorWave 650 User Manual

Enable the Roll-to-Roll mode

Enable the Roll-to-Roll mode
Introduction
When you want to use the take-up unit, your printer has to be in the Roll-to-Roll mode.
You can enable the Roll-to-Roll mode in the Océ Express WebTools. When you enable
the Roll-to-Roll mode, the printer will not cut between pages.
This section describes how to enable the Roll-to-Roll mode in the Océ Express WebTools.
Before you begin
Access the Océ Express WebTools. This setting can be edited by the Key Operator and
the System Administrator.
Note:
When the Roll-to-Roll mode is enabled, each print job is delivered to the 'External
output (back)'; even when you set the 'Top delivery tray' as output location for your
prints.
Note:
To calibrate the printer, the Roll-to-Roll mode must be disabled.
Enable the Roll-to-Roll mode
Go to 'Preferences' - 'System properties' - 'Job management' - 'Enable roll-to-roll mode'.
1.
Click the checkbox to enable the Roll-to-Roll mode.
2.
Click 'On'.
3.
Click 'Ok'.
4.
38 Chapter 2 - Get to know the printing system