Print A Job In Roll-To-Roll Mode - Oce ColorWave 650 User Manual

Print a job in Roll-to-Roll mode

Introduction
When you want to print a job in Roll-to-Roll mode, you must first prepare the take-up
unit. For correct winding it is important that you choose a core with a width that
matches the media you want to use. Then you can print and fine-tune the take-up unit.
Printing more than one job onto one roll
The printer automatically cuts your print when the time between jobs is more than three
minutes. So if you want to print more than one job onto one roll, you can collect your
jobs in a 'Smart Inbox'. When all your print jobs are collected, you can start printing.
Unattended/Overnight printing
The Roll-to-Roll mode allows you to print your print jobs unattended, for example
overnight. Replace nearly empty cartridges with full ones, to avoid that the machine stops
printing. You can use the nearly empty cartridge when you print attended print jobs.
Note:
To replace an empty cartridge during printing, pause the printer and replace the cartridge.
Note:
When you print in Roll-to-Roll mode, media drawer 1 is recommended.
Caution:
Not all media types are supported for Roll-to-Roll printing. Make sure that your media
is on the list of recommended media types for the take-up unit. See:
types for the take-up unit' on page
Prepare the take-up unit
#
Step
1
2
Action
Switch on the take-up unit
Select a 3" core with a width
that matches the media roll
you are going to use.
49.
Illustration
Chapter 2 - Get to know the printing system
Print a job in Roll-to-Roll mode
'Recommended media
39