The System Monitor - Oce ColorWave 650 User Manual

The system monitor

The system monitor
Introduction
You can open the system monitor to get an overview of the current status of the printing
system. When you click on the 'System' tab in the lower left corner of the screen, the
system monitor pops-up.
The system state (for example: 'Printing:') is displayed in the upper right corner of the
system monitor section of the Océ Express WebTools.
Overview of the system states
#
State
'User intervention re-
quired'
'System memory is full'
'Out of toner'
'Sleeping...'
'Warming up...'
'Initializing...'
'Printer paused'
'Processing...'
'Ready to print'
'Printing:' <job-name>
108 Chapter 4 - Configure the printing system
Icon Description
The user is requested to go to the printer and fol-
low the instructions displayed on the operator
panel.
Status message when printer does not print because
the system memory is full.
Status message when printer does not print because
the printer is out of toner.
Energy saving state: State when not all functional-
ity is available due to printer sleeping.
State when not all functionality is available due to
printer warming up.
State when the system software is initializing.
The system pauses the print queue but keeps access
to all other functionality.
The system is receiving or processing data.
State when there is no active job and no waiting
job.
When a job arrives, no user intervention is needed
to start printing.
State when a print job is active.