Print A Job In Roll-To-Roll - Oce ColorWave 650 User Manual

Step Action
4 If necessary, reposition and tighten
the flanges. For example, when the
media is wider than the core.
5 Check that the media creates a blouse
between the printer and the take-up
unit and if the unit winds up correct-
ly. You must pay special attention to
the edges, when the unit winds up
your print job automatically the first
time.
Note:
When the blouse reaches the
sensor at the bottom, the
take-up unit will wind your
prints. You can also use the
manual feed button to check
the winding.
6 Align the take-up unit by moving it
to the left-hand side or right-hand
side.
The unit is correctly aligned when
the blouse of your print is parallel to
the printer.
Print a job in Roll-to-Roll mode
Illustration
Chapter 2 - Get to know the printing system 43