Set The 'Network Duplex Mode' And The 'Network Speed - Oce ColorWave 650 User Manual

Set the 'Network duplex mode' and the 'Network speed'

Set the 'Network duplex mode' and the 'Network speed'
Introduction
Use the Océ Express WebTools to set the 'Network speed' and 'Network duplex mode'
for your network adapter.
Before you begin
Note:
Gigabit ethernet (1000 Mbit/s) is supported, but only by automatic detection.
Note:
For this procedure, you need to log in as a System Administrator or Power User.
Set the 'Network duplex mode' and 'Network speed'
In the Océ Express WebTools:
Open the 'Configuration' - 'Connectivity' tab.
1.
Click on 'Edit' in the 'Network adapter' section or click on the Network speed and duplex
2.
mode setting.
Select the correct value. 'Automatic detection' is default.
3.
Click on 'Ok' to confirm or 'Cancel' to reject your entries.
4.
116 Chapter 4 - Configure the printing system