SAGEMCOM F@ST 2804v2 Reference Manual page 98

5 - Information / Configuration
Field
PPP IP extension
Use Static IP Address
IP Address:
Retry PPP password on
authentication error
Configure PPP MTU
Enable PPP Debug mode Check the box to use the PPP Debug mode.
Bridge PPPoE frames
between WAN and local
ports
Only Bridge PPPoE
Frames
Note: The MTU specifies the maximum size of the data used (IP packets) expressed as a
number of bytes.
•
Click on the Next button to continue configuring the remote network (WAN) in PPPoE
mode.
F@st™ 2804v2 Reference Manual - 253329475-A
Page 5-62
Check the box to allocate the public address
obtained from the DHCP server of your
Internet Service Provider (ISP) to your
computer. Your router will then act as a bridge
between the server and your computer.
Check the box to use the static IP address.
5
Enter the static IP address.
Check the box, PPP can be retried again and
again while authentication fails
Enter an MTU (Maximum Transfer Unit) value.
This value (in bytes) is between 38 and 1492
(see Note).
In the event of connection failure, this option
will enable you to trace a possible problem in
the SYSLOG file.
Check the box to enable the router when
bridging the frames between WAN and local
Ethernet ports
Check the box to filter out all the non-PPPoE
packets when bridging the frames between
WAN and local ports.
Sagemcom document. Reproduction and disclosure prohibited
Action Default
_
_
0.0.0.0
Box
Not checked
1492
Box
Not checked
Checked
Checked