Interpreting The Leds; The "Adsl" Led Blinks Slowly; Wi-Fi" Led Off; All Leds Are Off - SAGEMCOM F@ST 2804v2 Reference Manual

A.5 Interpreting the LEDs
A.5.1

The "ADSL" LED blinks slowly

Check the connection of your ADSL filters. Each telephone socket of your installation which
is used must be equipped with an ADSL filter.
Check that the RJ11 type line cord delivered with your router is connected to one of your
sockets. It is recommended that no telephone extension is used.
Finally, check with your ISP on the availability of the ADSL service on your telephone line.
A.5.2

"Wi-Fi" LED off

If this LED is off, this indicates that the WLAN interface of the router is not active.
To activate the wireless network, check the box "Enable Wireless" in the "Basic" menu of the
"Wireless" heading of the HTTP configurator (see sub-section 5.7.1).
A.5.3

All LEDs are off

Check that the type of power available in your premises is compatible with the mains
voltage required for powering your router.
Check that the delivered power cord is properly connected at one end to the mains power
network.
Check that the power connector is inserted correctly in the corresponding connector (power)
of the router.
Sagemcom document. Reproduction and disclosure prohibited
Annex A - Troubleshooting
F@st™ 2804v2 Reference Manual - 253329475-A
Page A-7