SAGEMCOM F@ST 2804v2 Reference Manual page 72

5 - Information / Configuration
The table below indicates in more detail how to access your Wi-Fi port
(or Access Point).
Nevertheless, it is best to leave the default values for easier usage.
Field
AP Isolation
Band
Channel
Auto Channel Timer (min)
TM
54g Rate
Multicast Rate
Basic Rate
Fragmentation Threshold
F@st™ 2804v2 Reference Manual - 253329475-A
Page 5-36
Select from the scroll down list:
Off : to not isolate the Access Point i.e.
authorise machines connected to the
router to communicate with each other.
On : to isolate the Access point, i.e. prohibit
machines connected to the router to
communicate with each other.
Select the 2.4 GHz band for the IEEE 802.11g
standard.
See Wireless/Basic subsection 5.7.1.1.
Configure the duration, in minutes, during which
the router must seek the best wireless channel.
This option is only available when the selection of
the channel is configured in "Auto" (Automatic).
In the scroll down list, select the transmission rate
at which the information (data or video) will be
transmitted or received on your wireless network
(Auto, 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48 or
54 Mbps).
Note: If you select "Auto", the information will
be transmitted at an optimised rate
which takes account of the transmission
constraints.
From scroll down list, select the transmission rate
at which the "Multicast" packets are transmitted
(Auto, 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48 or
54 Mbps).
Note: If you select "Auto", the information will
be transmitted at an optimised rate
which takes account of the transmission
constraints.
Video conferencing and teleconferencing are
"Multicast" applications.
From the scroll down list, select the basic rate at
which the information will be transmitted or
received over your wireless network (Default, All,
1 & 2 Mbps or 1 & 2 & 5.5 & 6 & 11 & 12 &
24 Mbps).
This packet fragmentation mechanism is used to
limit errors and repetitions.
It is recommended not to reduce the packet size
too much to avoid reducing the bandwidth.
Enter a threshold value (in bytes) between 256
and 2347.
Sagemcom document. Reproduction and disclosure prohibited
Meaning Default
Off
2.4GHz-
802.11g
Auto
0
Auto
Auto
Default
2346