Avaya Octel 50 Installation Manual page 90

Setting Up the System
If Set Too High
If Set Too Low
0000
(12:00
AMIS Parameters - #48
End of Economy
Weekend Hours
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
0000
(12:00
AMIS Parameters - #49
Maximum
Number of
Attempts Before
Failure
Octel 50 Installation Guide
Min Max Default
2359 Blank
) (11:59 )
AM PM
Min Max Default
2359 Blank
(11:59
) )
AM PM
Configuring System Setup Parameters
Not applicable.
Not applicable.
Requires
Restart
No
This parameter defines the system-wide end of economy
dispatch hours for the weekend. During economy hours,
the Octel 50 system sends any casual or administered
network messages marked for economy dispatch since
the end of economy hours on the previous day.
Enter the hour and minutes that economy time ends in
military time. The same economy time is used for
Saturday and Sunday; you cannot specify different
economy times.
When setting economy hours, use the off-peak rate period
defined by the phone carrier. Many carriers have different
off-peak hours on the weekend.
It is recommended that you end the economy hours a few
minutes before the end of the lower rate period to allow for
discrepancies between the Octel 50 system clock and the
carrier's clocks.
The economy time frame can overlap into the next day.
For example, Sunday's time may extend into Monday
morning. In this case, the hours that extend into Monday
are still considered part of the weekend economy time.
You can use the Economy Dispatch fields on the AMIS
Node Entry dialog box to override economy hours for
individual nodes.
The Start of Economy Weekend Hours parameter
determines when economy hours begin.
Not applicable.
Not applicable.
Requires
Restart
No
This parameter defines the number of unsuccessful
dispatch attempts to an Administered node allowed before
the Octel 50 system deactivates the node. When a node is
inactive, subscribers may not send any messages to it until
you reactivate the node on the AMIS Node Entry dialog box.
This parameter only applies to Administered AMIS nodes.
Switch- Set by
Dependent Integrator
No No
Switch- Set by
Dependent Integrator
No No
8-30