Avaya Octel 50 Installation Manual page 150

Setting Up the System
If Set Too Low
Min
Hangup Detection Parameters - #169
Maximum
Silence Before
Hanging Up
(MAXSIL)
When/How to Use
Related Parameters/Features
If Set Too High
If Set Too Low
Min
Octel 50 Installation Guide
Max Default
0 30000 30
Max Default
0 30000 600
Configuring System Setup Parameters
Noise spikes on the line could cause disconnect. Set this
parameter to 0 to disable it.
A low setting may also cause call ghosting on the ports.
Requires
Restart Dependent
Yes
This parameter specifies the amount of time, in 10
millisecond units, during message recording that the Octel
50 system records silence before it determines the caller
has hung up and drops the line. MAXSIL prevents the Octel
50 system from recording silence when a caller has hung up
during a record session.
This parameter is used for switches that do not use positive
disconnects or dial tones to indicate disconnects.
For most Octel 50 systems, the default value should be
sufficient.
Set this parameter to a value less than 1000 if using AMIS
messaging.
Set this parameter to a value greater than 0 if using
HANGUPSTR.
The Octel 50 system records silence. Also, switches could
detect a port as available and mistakenly pass incoming
calls to a port on which Octel 50 system is recording silence
(missed disconnect). In this case, a new caller would
append to the previous recording.
Callers could be cut off during recording due to natural
pauses when they speak.
Requires
Restart Dependent
No
Switch- Set by
Integrator
Yes Yes
Switch- Set by
Integrator
Yes No
8-90